How do I adjust my External Regulator?

This application applies to the 52mm Reg Kit, Elites and the SF Models.

Tools that you will need: 5mm Hex Tool

  • INSERT TOOL INTO 5MM HEX SCREW/REGULATOR ADJUSTER SCREW ON THE BOTTOM OF THE REGULATOR NEXT TO THE AIR TANK PRESSURE GAUGE. (THE REGULATOR PRESSURE GAUGE IS ON THE RIGHT SIDE OF THE ELITE MODELS AND ON THE BOTTOM OF THE BLOCK ON THE SF MODELS) LOOKING AT THE REGULATOR ADJUSTER SCREW TURN IT COUNTERCLOCKWISE TO INCREASE AND CLOCKWISE TO DECREASE. YOU CAN'T DECREASE WHILE UNDER PRESSURE.
  • IF YOU WANT TO DECREASE YOU WILL HAVE TO DE-GAS THE GUN BY SLOWLY LETTING THE AIR OUT OF THE AIR TANK BY LOOSENING THE AIR GAUGE. ONCE THE AIR TANK IS EMPTY YOU WILL HAVE TO DRY FIRE THE GUN ONCE OR TWICE TO REMOVE ANY AIR HELD BY THE REGULATOR PLENUM.
  • ONCE ALL THE AIR HAS BEEN REMOVED FROM THE GUN YOU CAN MAKE THE REGULATOR ADJUSTMENT. AFTER YOU MADE YOUR REGULATOR ADJUSTMENT YOU SIMPLY FILL YOUR AIR TANK BACK UP AND YOUR GOOD TO GO.
  • NEVER DECREASE WHILE UNDER PRESSURE, IT WILL DAMAGE THE REGULATOR AND VOID THE WARRANTY.
  • TO INCREASE REGULATOR PRESSURE, YOU DO NOT HAVE TO DE-GAS THE GUN. WHEN INCREASING OR DECREASING PLEASE DO NOT TURN THE REGULATOR ADJUSTING SCREW MORE THEN 1/4 TURN AND THEN CHECK YOUR RESULTS.
  • PLEASE DO NOT OVER ADJUST, THIS ALSO WILL DAMAGE THE REGULATOR. A CHRONOGRAPH WILL HELP MEASURE YOUR RESULTS.

 

    Â